Drawing of a shrimp in an aquarium next to a water test tube

Shrimp Water Parameters: GH, KH, pH and TDS in Plain English

Our verdict: for shrimp, hardness (GH and KH) and stability matter more than any single “perfect” number. Test GH, KH and pH, match your water changes to the tank, and do not chase TDS readings if the shrimp are healthy.

Fish forgive a wrong pH or a hardness swing far more than shrimp do. Practical Fishkeeping says dedicated shrimp breeders agree that GH and KH must be right, while few of them think TDS (total dissolved solids) matters much, and many never check it. Their reasoning: TDS rises with leftover waste or added salt, so a “correct” reading can hide the wrong minerals. Shrimp Science makes a similar point and calls TDS a less accurate shortcut for water chemistry. For the terms themselves, see our glossary.

Typical ranges by shrimp

ShrimpTemperaturepHHardness
Cherry shrimp15 to 30 °C (SS); 18 to 26 °C (PF)6.5 to 8GH 4 to 10, KH 1 to 8, TDS 100 to 250 (SS); 8 to 18 °dH, KH 5 to 15 (PF)
Amano shrimp18 to 28 °C (SS); 15 to 28 °C (FK)6.0 to 7.5 (SS); 6 to 8 (FK)GH 5 to 15, KH 0 to 10, TDS 100 to 300 (SS); 6 to 18 dH (FK)
Crystal red (bee) shrimp20 to 25 °C (SS); 18 to 23 °C (PF)5.5 to 7.0 (SS); 6 to 6.8 (PF)GH 4 to 6, KH 0 to 2, TDS 100 to 180 (SS); about 5 °H, KH 0 to 2 (PF)
Sulawesi shrimp27 °C and aboveabout 8.5GH 4 to 8, KH 3 to 5 in their home lakes (PF)
Bamboo shrimp23 to 29 °C6.5 to 7.56 to 15 dH

SS = Shrimp Science, PF = Practical Fishkeeping, FK = Fishkeeper. Where only one source is listed for a row, the others did not give a figure. Practical Fishkeeping writes hardness as “°H”; we read this as German degrees (°dH).

Where the sources disagree

  • Water-change rhythm: Fishkeeper advises small partial water changes a few times a week for crystal red shrimp. Shrimp Science recommends a fixed schedule that leaves the shrimp stable for a week or two, rather than small, frequent changes every few days. Practical Fishkeeping notes that large, frequent changes can trigger premature moults. We lean towards the steadier approach, matched closely to the tank water.
  • Cherry shrimp hardness: the two sources overlap only at GH 8 to 10. See our cherry vs bee shrimp guide.
  • Hot-water shrimp: Sulawesi shrimp need warm, alkaline, moderately soft water. That is the opposite of the “soft and acidic” advice for bee shrimp.

Changing water without shocking shrimp

A shrimp that has just shed its shell takes in water to grow. Shrimp Science explains that if the new water is much softer or harder than the tank, the sudden difference can be deadly for a freshly moulted shrimp. Its advice:

  • Match the new water to the tank as closely as you can: TDS, GH, KH and temperature.
  • Add it slowly, for example with a drip line.
  • Stick to a regular schedule instead of reacting to every reading.

For new arrivals, Practical Fishkeeping recommends dripping tank water into their bag or container at one to two drops per second for about an hour, until the volume has tripled or quadrupled. Use our RO water mixing calculator to blend RO and tap water to a target hardness, and see moulting in shrimp for what goes wrong when parameters swing.

What to test

  • Ammonia and nitrite: any reading is a problem. Cycle the tank first (how to cycle a new aquarium).
  • GH and KH: before you add shrimp and after any change in water source.
  • pH: to confirm stability, especially with active substrates.
  • TDS: optional. Shrimp Science notes it varies a lot with tap water, so use it for trends, not as a pass mark.

Get new guides by email

New fish profiles and guides, in one short email. No spam, unsubscribe any time. See our privacy policy.