Tropical fish like warmth, but a tank in a hot flat can climb well past what is healthy. Warm water also holds less oxygen, while bacteria in the tank compete with the fish for what is left. The aim in a heatwave is to cut heat going in, move more air through the water and avoid sudden changes.
Steps that help
- Switch the light off or shorten it. Lights add heat. Planted tanks need some light, so shorten rather than cut it if you have many plants.
- Leave the heater alone. It will not switch on in hot weather, and switching it off completely risks forgetting to turn it back on later.
- Point a fan across the water surface. This cools by evaporation. Expect to top up more often, ideally with RO water.
- Block direct sun with curtains or blinds, and insulate the back and sides, leaving the top open for gas exchange.
- Add an airstone or more surface movement, especially at night in planted tanks, since plants use oxygen when the light is off.
- Clean a dirty pump impeller. A fouled pump produces extra heat.
- Do a small cool water change, dropping the temperature by no more than a couple of degrees at a time.
What to avoid
- Dropping ice straight into the tank.
- Big, cold water changes, which cause rapid temperature swings.
- Reducing surface movement.
Signs of overheating
Gasping at the surface, fast gill movement, lethargy, hanging near the filter outlet, loss of appetite or erratic swimming. There is no single safe ceiling: it differs by species, and neon tetras struggle before rams do. Check the range for your fish in our stocking checker and care guides.
Related: what to do in a power cut and the running cost calculator.
Sources
- Nathan Hill, “How to cool your aquarium in a heatwave”, Practical Fishkeeping, 2019, updated 2026.
One hobby-magazine source; we have not tested these steps ourselves. Full list on our sources page.


Leave a Reply